Philips 9000 Series Manual page 21

3 Hold the beard styler attachment perpendicular to the skin and
move the appliance downwards while you exert gentle pressure
(Fig. 32).
4 Clean the attachment after use (see 'Cleaning and maintenance').
Cleaning and maintenance
The accessories supplied may vary for different products. The box
shows the accessories that have been supplied with your appliance.
Cleaning the shaver in the SmartClean system
SmartClean system Plus has two phases: the rinsing phase and the
drying phase (Fig. 33).
Preparing the SmartClean system for use
Caution: Do not tilt the SmartClean system to prevent leakage (Fig.
34).
Note: Hold the SmartClean system while you prepare it for use.
Note: If you clean the shaver in the SmartClean system once a week,
the SmartClean cartridge lasts approximately three months.
1 Put the small plug in the back of the SmartClean system.
2 Put the supply unit in the wall socket.
3 Press the button on the side of the SmartClean system (1) and lift
the top part of the SmartClean system (2).
4 Pull the seal off the cleaning cartridge (Fig. 36).
5 Place the cleaning cartridge in the SmartClean system (Fig. 37).
6 Push the top part of the SmartClean system back down ('click')
(Fig. 38).
Using the SmartClean system
Caution: Always shake excess water off the shaver before you
place it in the SmartClean system (Fig. 39).
1 Press the top cap to be able to place the shaver in the holder
('click') (Fig. 16).
2 Hold the shaver upside down above the holder. Make sure the
front of the shaver points towards the SmartClean system (Fig. 17).
17
English