Make Front Table Flat - Craftsman 509398 Owner's Manual

Assembly

Make Front Table Flat

1. Place rear table on its edge, across cen-
ter of front table. Check for gap between sur-
faces.
If there is less than 1/32" gap, tighten cup
point set screw until it touches frame (look
underneath table), then tighten center (1-3/4"
long pan head screw.
If there is more than 1/32" gap, close gap
by raising or lowering center of front table:
to raise center, tighten cup point set screw
against frame;
to lower center, tighten center (1-3/4" long)
pan head screw.
2. When gap is closed, make sure cup point
set screw touches frame (look underneath
table), and center (1-3/4" long) pan head
screw is tightened.
NOTE: Rip fence scale is no longer correct.
Measure distance between fence and blade
for correct distance when in rip mode.
16