Installing Front Table - Craftsman 509398 Owner's Manual

Installing Front Table

1. Set out:
- front table
- tee nut
- 1/4 " U-clip
- 1/4" diam. x 7/8" long cup point set
screw
- four 1/4" diam. x 1" long pan head
screws
- 1/4" dia. x 1-3/4" long pan head screw
- five 17/64" I.D. x 5/8" O.D. flat washers
- four 1/4" lockwashers
- four 1/4" diam. hex nuts
2. Identify top and bottom of table: top has
counterbored holes. Place table bottom side
up on solid surface. Hammer tee nut into lev-
eling hole. (This hole is not counterbored
from the top).
3. Slide a U-Clip onto the center channel of
the saw as shown.
4. Place the front table on the saw so that
the mounting holes in the table line up with
holes in the table supports and center chan-
nel of saw .
5. Drop a flat washer into each counter-
bored hole.
6. Start 1-3/4" long pan head screw through
center hole and into U-clip, but do not fully
tighten.
7. Start cup point set screw through leveling
hole and into tee nut, but do not fully tighten.
8. Put 1" long pan head screw in each of
four remaining holes and through matching
holes in table supports. On end of each
screw, put lockwasher then nut and tighten
with screwdriver.
~
Table Mounting Holes
Top of Table
(Counterbored Holes Up
Bolt
Washer
Lockwasher
Hex Nut
Assembly
Tee Nut
(Install from bottom)
U-Clip
Set Screw
Leveling Hole
Pan Head Screw
Washer
Mounting Holes
15