NEC Express5800/R120h-1E Manual page 34

● Caution about Virtual NIC settings on iLO Web interface
The default value for "Virtual NIC" in [Security]-[iLO] depends on the version of the iLO 5 firmware.
Check the following when "Set to factory default" is executed in the BMC configuration utility.
(1) If you use iLO 5 firmware version between 2.10 and 2.18, The default value of "Virtual NIC" is "Enabled".
A warning may be displayed for "Virtual NIC" on the device manager of Windows Server 2012 R2 which does not
support virtual NIC or Windows Server 2016/2019 where USB CDC-EEM driver is not installed.
If you do not use the iLO virtual NIC functionality, go to [Security] > [iLO], and disable "Virtual NIC".
(2) If you use iLO 5 firmware version between 1.40 and 1.47 or 2.31 or later, The default value of "Virtual NIC" is "Disabled".
When you run "Set factory defaults" on BMC Configuration Utility, [Security] > [iLO] > "Virtual NIC" will be "Disabled".
● Caution about IPv6 address of Network Adapter on iLO Web interface if vEthernet(Hyper-V Virtual
Ethernet Adapter) is configured on Windows
If iLO version between 2.10 and 2.18 below is used and vEthernet(Hyper-V Virtual Ethernet Adapter) is configured on
Windows, "IPv6 Address" of [Network Ports] in each Adapter may be not accurate on [Information] > [Network] > [Physical
Network Adapters].
Please comfirm The Property of each network apater on Windows, if vEthernet(Hyper-V Virtual Ethernet Adapter) is
configured on it.
● Displaying Network information in the iLO web interface
If iLO version 2.31 or later is used and Bridge of network is configured on OS, the information in each Adapter may be not
accurate on [Information] > [Network] > [Physical Network Adapters].
Please comfirm The Property of each network apater on OS, Bridge of network is configured on it.
● Caution for the Security Dashboard of iLO Web interface
If you update to iLO5 firmware greater than or equal to 1.43 and lower than 2.10, "Last Firmware Scan Result" is displayed
in "Information > Security Dashboard". Do not click this Hyperlink.
If you click this link by mistake, you won't be able to move between menus and tabs.
In that case, you need to reload the page by the reload button of the browser.
Or you log out the current session of iLO Web interface, and please log in again.
34