Maintenance; Lubrication; Extension Cords - Craftsman 315.2121O0 Owner's Manual

WARNING: W hen servicing, usaonlyidentical
Craftsman replacement parts. U seofanyother
part
m ay create a hazard or cause product
damage.
GENERAL
Avoid usingsolvents when cleaning plasticparts.
Most plasticsare susceptibleto damage from vadous
types of commercial solventsand may be damaged
by their usa. Usa clean clothsto remove dirt, carbon
dust, etc.
EXTENSION CORDS
The usa of any extensioncord will cause some loss of
power. To keep the loss to a minimumand to prevent
tool overheating, usa an extension cord that is heavy
enoughto carry the current the tool will drew.
A wire gage size (A.W.G.) of at least 14 is recom-
mended for an extension cord 25 feet or less in
length.When workingoutdoors,usa an extension
cord that is suitable for outdoorusa. The cord's jacket
will be marked WA.
,_ WARNING: Do not at any time let brake fluids, _ cuttingCAUTION:area andKeeppositionextensi°nthe cordScord soaWaythat fromit willthe
gasoline, petroleum-basedproducts, penetrating not get caught on lumber,tools, etc., dudng
cutting operation.
oils, etc. come in contact with plastic parts. They
containchemicals that can damage, weaken or
destroyplastic.
it has been found that siectric toolsare subjectto
accelerated wear and possiblepremature failure when
they are used on fiberglass boats, sports cars,
wallboard,spacklingcompounds, or plaster. The
chips and gdndingsfrom these matedals are highly
abrasiveto siectdc tool parts such as bearings,
brushes,commutators, etc. Consequently, it is not
recommendedthat this tool be used for extended
work on any fiberglass material, wallboard, spackling
compounds,or plaster. During any use on these
matedais it is extremely importantthat the tool is
cleaned frequentlyby blowingwith an air jet.
LUBRICATION
WARNING: Check extension cords before each
usa. If damaged, replace immediately.Never usa
tool with a damaged cord since touchingthe
damaged area could cause electdcal shock
resulting in sedous injury.
_k WARNING: Always wear safety gogglesor
safety glasses with side shields dudngpower
tooloperation or when blowing dust. If operation
is dusty,also wear a dust mask.
All of the bsadngs in this tool are lubricatedwith a
sufficientamount of high grade lubricantfor the life of
the unit under normal operating conditions.Therefore,
no further lubricationis required.
27