Support Long Workpieces - Craftsman 315.21234 Operator's Manual

n Grasp the saw handle firmly then squeeze the switch
trigger. Allow several seconds for the blade to reach
maximum speed.
n Slowly lower the blade into and through the workpiece.
n Release the switch trigger and allow the blade to stop
rotating before raising the blade out of workpiece. Wait
until the electric brake stops blade from turning before
removing the workpiece from miter table.

SUPPORT LONG WORKPIECES

See Figure 37.
Long workpieces need extra supports. Supports should
be placed along the workpiece so it does not sag. The
support should let the workpiece lay flat on the base
of the saw and work table during the cutting operation.
Use the optional work clamp or a C-clamp to secure the
workpiece.
WARNING:
To avoid serious personal injury, always
keep hands outside the no hands zone; at least 3
in. from blade. Never perform any cutting operation
freehand (without holding workpiece against the
fence). The blade could grab the workpiece if it slips
or twists.
LONG WORKPIECE
WORKPIECE SUPPORTS
OPERATION
27
45 X 45 COMPOUND MITER CUT
° °
Fig. 36
Fig. 37