MTD 600 Series Operator's Manual page 7

Standard Side Crank Chute Control
1. Position chute assembly over base.
See Figure 2-9.
Figure 2-9
2. Close flange keepers to secure chute
assembly to chute base. Flange keepers
will click into place when properly
secure. See Figure 2-10.
Figure 2-8
Figure 2-10
NOTE:
Ensure the lower chute is
secured to the flange on the chute base.
The lower edge of the chute keeper
should be positioned below the flange
on the chute base after being clicked
into place. If flange keepers will not
easily click into place, use palm of your
hand to apply swift, firm pressure to the
back of each.
Chute Directional Control
Assembly
1. Remove plastic cap (if present), flat
washer (a) and hairpin clip (b) from end
of chute directional control assembly.
See Figure 2-11.
(a)
Figure 2-11
2. Insert end of chute directional control
assembly into lower bracket and secure
chute directional control assembly
with flat washer (a) and hairpin clip (b)
removed in Step 1. If necessary, lower
bracket can be adjusted. Refer to Chute
Bracket Adjustment in Service section
on page 21.
STOP!
Continue to Set-Up
(page 14).
STOP
S 2 — A & S
ection SSembly et
(b)
-U 7
p