MTD 600 Series Operator's Manual page 10

Two & Four Way Chute Control
1. Remove hairpin clip (a), wing nut (b) and
hex screw (c) from chute control head
and clevis pin (d) and bow-tie cotter pin
(e) from chute support bracket.
See Figure 2-23.
Chute
(c)
Control Head
(a)
(d)
(b)
Chute
Chute
Base
Figure 2-23
2. Insert chute control rod into chute
control head. Push rod as far into chute
control head as possible, keeping holes
in rod pointing upward. See Figure 2-24.
10 S 2 — A
ection SSembly
Figure 2-22
Chute
Support
Bracket
(e)
3. Place chute onto chute base and ensure
chute control rod is positioned under
handle panel. Install hex screw (c)
removed in Step 1, but do not secure
with wing nut at this time.
See Figure 2-25.
& S -U
et p
Figure 2-24
(c)
Figure 2-25
4. Squeeze trigger on joystick and rotate
chute by hand to face forward. The holes
in chute control input will be facing up.
See Figure 2-26.
Chute Control Input
Figure 2-26
Top View
Joystick