Installation - universalblue UM20SGBL-18 Instruction Manual

2.

INSTALLATION

1. Take out all the packing. If there is a safe film over the oven, take it off before use.
Check carefully for damage. If any, immediately notify dealer.
2. Microwave ovens must be placed under dry and non-corrosiveness environments,
kept away from heat and humidity, such as gas burner or water tank.
3. To ensure sufficient ventilation, the distance of the back of microwave to the wall
should be at least 10 cm, the side to the wall should be at least 15 cm, the free
distance above the top surface at least 30 cm. the distance of the microwave to the
ground should be at least 85 cm.
4. The position of the oven shall be such that it is far from the TV, Radio or antenna as
picture disturbance .Or noise may occur.
5. The appliance must be positioned so that the plug is accessible, and must ensure a
good grounding in case leakage, ground loop can be formed to avoid electric shock.
6. The microwave oven must be operated with the door closed.
7. The microwave oven must not be placed in a cabinet. The microwave oven is
intended to be used freestanding. Do not place any object on the top.
8. The back of the oven must be placed against a wall
9. As there is manufacturing residue or oil remained on the oven cavity, it usually would
smell the odor, even a slight smoke, It is normal case and would not occur after
several times use, keep the door or window open to ensure good ventilation.
IMPORTANT
The wires in this mains lead are coloured in accordance with the following code:
 Green-and-yellow: Earth
 Blue: Neutral
 Brown: Live
As the colours of the wires in the mains leads of the appliance may not correspond
with the coloured markings indentifying the terminals in your plug, proceed as
follows:
 The wire which is coloured green-and-yellow must be connected to the
therminal in the plug wich is marked with the letter E or
symbol coloured green og green-and-yellow.
 The wire which is coloured blue must be connected to the terminal which is
marked with the letter N or coloured black.
 The wire which is coloured Brown must be connected to the terminal which is
marked with the letter L or coloured red.
by the earth
17