Threading 4 Thread Cover Stitch; Threading Cover Stitch Looper - JUKI MCS-1800 Instruction Manual

Threading 4 thread cover stitch

1
2
2
5
3
6
4
5
3 6
4
13
12
14
13
3
13
8
9 12
7
10
11
1. Threading cover stitch looper (purple)
• Switch the machine off (Power switch to "0").
Place the spool on the spool holder pin as illustrated.
(1) Bring the thread up from the spool and lay it from the
back to the front into the guides.
(2, 3) Thread the guides.
(4) Thread the tension dial.
(5, 6, 7) Thread the guides.
(8) Place the thread horizontally in the guide.
(9) Thread the guide.
Bring the needle into the lowest position. Turn handwheel.
(10) Thread the guide.
(11) Push the looper auto-threader (white) up towards the
chainlooper and press them down together.
(12) Thread the first looper eye back to front.
(13) Thread the looper eye front to back and cut thread to
about 10cm (4").
(14) Push the looper auto-threader back up to sewing
position.
Raise the needle to highest position (turn handwheel)
Note:
If the looper thread has to be re-threaded, cut the needle
threads above the needle eye and remove. Thread the
looper first and then the needles.