Care And Maintenance - ECG BD 35 Instruction Manual

WALL MOUNT OF THE DEVICE
The dispenser package includes a wall mount bracket. The
bracket can be attached to the wall using either an adhesive
foam pads, or using screws. We recommend using adhesive
foam pads for mounting on ceramic tiles. We recommend
using screws for mounting the bracket on a drywall or wooden
surface, however, it is possible to use the adhesive foam pad
as well.
The installation on a selected location is facilitated by the
included paper template with dimensions corresponding to
the bracket.
Mounting with screws:
Place the template on the location where you want to install the bracket. Mark the position of two holes
for screws. Remove the template and drill two holes of 4,75 mm diameter. Insert screw anchors in the holes
and screw the bracket in place. Set the device on the two protrusions of the bracket and gently push down
to secure the device in the bracket. The device can be easily removed by pushing it up and taking it off the
protrusions of the bracket.
Mounting using foam pad:
Remove the protective paper from one side of the adhesive pad and stick the pad gently to the rectangular
area marked on the back of the bracket. Wipe the wall in the place where you want to install the dispenser
with dry cloth until it is dry and clean. DO NOT ATTEMPT TO INSTALL THE DEVICE IMMEDIATELY AFTER
SHOWERING WHEN THE WALLS ARE NOT PERFECTLY DRY. At the location of the planned installation put
the template to the wall, and carefully remove the protective paper from the other side of the adhesive
pad. Carefully place the bracket into the cut in the template and press fi rmly to the wall. Then remove the
template. Allow the bracket 12 hours to adhere to the wall before inserting the dispenser. Then fi t the device
on the two protrusions of the bracket and push it down gently to secure the device in the bracket. The device
can be easily removed by pushing it up and taking it off the protrusions of the bracket.
IMPORTANT RECOMMENDATIONS FOR TROUBLE FREE OPERATION
• Touch-free soap dispenser uses a sensitive infrared sensor, which detects the presence of your hands and
starts dispensing. To prevent unwanted dispensing, do not place the touch-free dispenser in direct
sunlight.
• After a long period of inactivity, the liquid in the dispenser may dry out and clog the dispensing nozzle.
In such an event, use simply a toothpick or something similar and remove the obstacle in the clogged
nozzle.

CARE AND MAINTENANCE

• If you do not plan to use the dispenser for several weeks, remove the batteries.
• If you do not plan to use the dispenser for a longer period of time, empty the container and rinse it with
water using the rinse function.
• The only parts of the dispenser constructed for continuous contact with water are the soap container
and the dispensing nozzle. Immersing the device in water may damage it.
EN
• Clean the exterior of the device using wet cloth only. Do not use aggressive cleaning products.
• Do not attempt to dismantle or repair the device. Unauthorized repair or modifi cations will void your
warranty.
32