Table of Contents
Advertisement
1MRK 506 377-UEN Rev. L
Although warning hazards are related to personal injury, it is necessary to understand that under
certain operational conditions, operation of damaged equipment may result in degraded process
performance leading to personal injury or death. It is important that the user fully complies with all
warning and cautionary notices.
1.4.2
Document conventions
•
Abbreviations and acronyms in this manual are spelled out in the glossary. The glossary also
contains definitions of important terms.
•
Push button navigation in the LHMI menu structure is presented by using the push button icons.
For example, to navigate between the options, use
•
HMI menu paths are presented in bold.
For example, select Main menu/Settings.
•
LHMI messages are shown in Courier font.
For example, to save the changes in non-volatile memory, select Yes and press
•
Parameter names are shown in italics.
For example, the function can be enabled and disabled with the Operation setting.
•
Each function block symbol shows the available input/output signal.
•
•
•
Dimensions are provided both in inches and millimeters. If it is not specifically mentioned then
the dimension is in millimeters.
1.5
IEC 61850 edition 1 / edition 2 mapping
Function block names are used in ACT and PST to identify functions. Respective function block
names of Edition 1 logical nodes and Edition 2 logical nodes are shown in the table below.
Table 1:
Function block name
-
-
AGSAL
ALMCALH
ALTIM
Table continues on next page
Railway application RER670
Commissioning manual
The caution icon indicates important information or warning related to the concept
discussed in the text. It might indicate the presence of a hazard which could result in
corruption of software or damage to equipment or property.
The information icon alerts the reader of important facts and conditions.
The tip icon indicates advice on, for example, how to design your project or how to
use a certain function.
the character ^ in front of an input/output signal name indicates that the signal name may
be customized using the PCM600 software.
the character * after an input signal name indicates that the signal must be connected to
another function block in the application configuration to achieve a valid application
configuration.
IEC 61850 edition 1 / edition 2 mapping
Edition 1 logical nodes
© 2017 - 2022 Hitachi Energy. All rights reserved
and
-
-
AGSAL
SECLLN0
ALMCALH
-
GUID-96DFAB1A-98FE-4B26-8E90-F7CEB14B1AB6 v9
.
.
GUID-C5133366-7260-4C47-A975-7DBAB3A33A96 v9
Edition 2 logical nodes
ALGOS
ALSVS
AGSAL
ALMCALH
ALTIM
Section 1
Introduction
13
Advertisement
Table of Contents
