Restart; Safe Shut Down - Panasonic EBL512 G3 Operating Instructions Manual

25. RESTART

A restart will delete or not delete the data in EBL512 G3. Below follows an explanation of the different data, abbreviations and a
table showing how the data respectively is affected, cold or warm restart.
FF
= Fire alarms and Faults
D = Disablements
FFD
= Fire alarms, Faults and Disablements
SSW = Sensor min. / max. values & performance factor, passwords, supervised output calibration values and event logs
WASV = Week Average Sensor Values
SSD
= Site Specific Data, i.e. all the installation programming created and downloaded via EBLWin
S/W = Software, the EBL512 G3 system program
The date & time and alarm counter value is stored in the memory of the real time clock, i.e. the value will be retained also after the
c.i.e. has been powered off (de-energized).
After any restart, a new week average sensor value will be calculated within two minutes, for all the ana-
log smoke detectors. During these two minutes all fire alarms from analog smoke detectors will be sup-
pressed. Thereafter a new average sensor value will be calculated each week.

25.1. SAFE SHUT DOWN

Safe shut down of control unit via menu H8/S6 will save the SSW data in a Flash ROM. in EBL512 G3. Before the first "Safe shut
down" this memory is empty. After each "Safe shut down" the latest SSW data is saved. (Safe shut down will not save the week
average sensor values)
a) Activate safe shut down via menu H8/S5.
b) Power off (de-energize)
When EBL512 G3 is powered up, the RAM will, after the restart, read the SSW data saved in the Flash ROM.
82