Digital Input Configuration Parameters - Inp - Emerson Dixell Full Touch XR20T Installing And Operating Instructions

LoF Light output OFF when in stand-by
LAU Light output ON after power-on
5.1.9 Digital input configuration parameters – inP
LABEL DESCRIPTION
ibt Base times for digital input 1
i1P Digital input 1 polarity
i1F Digital input 1 configuration
Digital inputs 1 alarm delay (base
did
time depends on par. ixt)
i2P Digital input 2 polarity
i2F Digital input 2 configuration
Digital inputs 2 alarm delay (base
d2d
time depends on par. ixt)
1592040000 XR20-30-60-70T EN v1.5 2023.10.12.docx
n=light output status unchanged after
n(0); Y(1) stand-by. Y=light output switched off after
stand-by.
n=light output unchanged; Y=light output
n(0); Y(1)
forced ON.
RANGE
SEC = seconds; Min = minutes. Delay in
SEC(0); Min(1) activating the function linked to the digital
inputs.
oP = activated by opening the contact;
OP(0); CL(1)
CL = activated by closing the contact.
• nu=not used
• dor = door switch function
• dEF = defrost activation
• AUS = auxiliary output
• ES = energy saving mode activation
• EAL = external warning alarm
nu(0); dor(1);
• bAL = external lock alarm
dEF(2); AUS(3);
• PAL = external pressure alarm
ES(4); EAL(5);
• FAn = evaporator fan control
bAL(6); PAL (7);
• HdF = holiday defrost
Fan(8); HdF(9);
• onF = ON/OFF status change
onF(10); LiG(11);
• LiG = light output control
CC(12); EMt(13);
• CC = pull down activation
MAP(14)
• EMt = X-MOD motion detection sensor
• MAP = reload factory default
configuration (for the used parameter
map)
• SAn = Sanitization
• EFn = Air extraction fan activation
delay between the detection of an
0 to 255 min/sec external event and the activation of the
relative function.
oP = activated by opening the contact;
OP(0); CL(1)
CL = activated by closing the contact.
• nu=not used
• dor = door switch function
• dEF = defrost activation
• AUS = auxiliary output
• ES = energy saving mode activation
• EAL = external warning alarm
• bAL = external lock alarm
nu(0); dor(1);
• PAL = external pressure alarm
dEF(2); AUS(3);
• FAn = evaporator fan control
ES(4); EAL(5);
• HdF = holiday defrost
bAL(6); PAL (7);
• onF = ON/OFF status change
FAn(8); HdF(9);
• LiG = light output control
onF(10); LiG(11);
• CC = pull down activation
CC(12); EMt(13)
• EMt = X-MOD motion detection sensor
• MAP = reload factory default
configuration (for the used parameter
map)
• SAn = Sanitization
• EFn = Air extraction fan activation
delay between the detection of an
0 to 255 min/sec external event and the activation of the
relative function.
XR20-30-60-70T
MEANING
no
no
VALUE
Sec
CL
nU
0
CL
nU
0
22/38