Jumper Settings - Supermicro AOC-A100G-b2CM User Manual

Super AOC-A100G-b2CM/G User's Manual

2.5 Jumper Settings

Explanation of Jumpers
To modify the operation of the motherboard, jumpers
can be used to choose between optional settings.
Jumpers create shorts between two pins to change
the function of the connector. Pin 1 is identified with
a square solder pad on the printed circuit board. See
the motherboard layout pages for jumper locations.
Note: JPAUX1 is for production use only.
JPAUX1 for Standby Power
Disable
No standby power to AOC
NIC
Enable
Standby power to AOC NIC
JPAUX1 for Standby Power
Disable
No standby power to AOC
NIC
Enable
Standby power to AOC NIC
IPMI Support FailOver
Support
Yes Yes
Yes
Yes
Function
Disable jumper
to disconnect the
standby power
Enable jumper to
connect standby
power to AOC NIC
18
Connector
1
Pins
Jumper
Cap
1
Setting
Pin 1-2 (Short)
WoL
Support
No
Yes
Notes
Default
WoL is supported on port 1
ONLY but limited to platforms
with sufficient airflow when it
is in standby mode (S5 state).
Please consult Supermicro
before enabling it.
2 3
2 3