Preparation; Before You Begin; Tools And Parts Needed; Parts Included - Thermador M271ES Installation Manual

Preparation

Before you Begin

Tools and Parts Needed

Parts Included

27" Appliances

General Information

Power Requirements
Dimensions for 27" Wall-Mounted Units
• Phillips head screwdriver
• Measuring tape
• Drill with bit (1/8")
• Phillips head screws (6)
The outlet must be properly grounded in accordance with all applicable codes.
Single Oven 27"
It is good practice, when oven is
installed at the end of a cabinet run,
adjacent to a perpendicular wall or
cabinet door, to allow at least 1/4"
space between the side of the oven
and the wall/door.
For oven support, install 2x4's
extending front to back flush with the
bottom and the side of the opening.
The supporting base must be well
secured to the floor/cabinet and level.
Note: The conduit box must be
installed either above or below the
unit. If the conduit box is installed
below the unit, a 2" diameter hole or
space is required between the back
wall and the right rear of the 2x4
supports.
The cabinet base must be flat and
capable of supporting a weight of at
least 210 lbs (95 kg).
English 3