Table of Contents
Advertisement
Available languages
Available languages
1 Important safety instructions
This section contains safety instructions that will help protect from
risk of personal injury or property damage. Failure to follow these
instructions shall void any warranty.
General safety
•
8 years and older children and people with reduced
physical, sensory, and mental abilities as well as unskilled
or inexperienced persons can use this appliance provided
that they are supervised and instructed on safe use of the
appliance as well as to the related dangers. Children should
not play or tamper with the appliance. Cleaning and user
maintenance should never be performed by children unless
supervised by a responsible adult.
•
Never place the product on a carpet-covered floor; otherwise,
lack of airflow beneath the machine will cause electrical parts
to overheat. This will cause problems with your product.
•
Do not operate the product if the power cable / plug is
damaged. Call the Authorized Service Agent.
•
Have a qualified electrician connect a 16-Ampere fuse to the
installation location of the product.
•
If the product has a failure, it should not be operated unless it
is repaired by the Authorized Service Agent. There is the risk
of electric shock!
•
This product is designed to resume operating in the event of
powering on after a power interruption. If you wish to cancel
the programme, see "Cancelling the programme" section.
•
Connect the product to a grounded outlet protected by a fuse
complying with the values in the "Technical specifications"
table. Do not neglect to have the grounding installation made
by a qualified electrician. Our company shall not be liable for
any damages that will arise when the product is used without
grounding in accordance with the local regulations.
•
The water supply and draining hoses must be securely
fastened and remain undamaged. Otherwise, there is the risk
of water leakage.
•
Never open the loading door or remove the filter while there
is still water in the drum. Otherwise, risk of flooding and injury
from hot water will occur.
•
Do not force open the locked loading door. The loading door
will be ready to open just a few minutes after the washing
cycle comes to an end. In case of forcing the loading door to
open, the door and the lock mechanism may get damaged.
•
Unplug the product when not in use.
•
Never wash the product by spreading or pouring water onto
it! There is the risk of electric shock!
•
Never touch the plug with wet hands! Never unplug by pulling
on the cable, always pull out by grabbing the plug.
•
Use detergents, softeners and supplements suitable for
automatic washing machines only.
•
Follow the instructions on the textile tags and on the
detergent package.
•
The product must be unplugged during installation,
maintenance, cleaning and repairing procedures.
•
Always have the installation and repairing procedures carried
out by the Authorized Service Agent. Manufacturer shall not
be held liable for damages that may arise from procedures
carried out by unauthorized persons.
Intended use
•
This product has been designed for domestic use. It is not
suitable for commercial use and it must not be used out of its
intended use.
•
The product must only be used for washing and rinsing of
laundry that are marked accordingly.
•
The manufacturer waives any responsibility arisen from
incorrect usage or transportation.
Children's safety
•
Electrical products are dangerous for the children. Keep
children away from the product when it is in use. Do not let
them to tamper with the product. Use child lock to prevent
children from intervening with the product.
•
Do not forget to close the loading door when leaving the
room where the product is located.
•
Store all detergents and additives in a safe place away from
the reach of the children.
2 Installation
Refer to the nearest Authorised Service Agent for installation of the
product. To make the product ready for use, review the information
in the user manual and make sure that the electricity, tap water
supply and water drainage systems are appropriate before calling
the Authorized Service Agent. If they are not, call a qualified
technician and plumber to have any necessary arrangements
carried out.
Preparation of the location and electrical, tap water and
C
waste water installations at the place of installation is under
customer's responsibility.
Installation and electrical connections of the product must be
B
carried out by the Authorized Service Agent. Manufacturer
shall not be held liable for damages that may arise from
procedures carried out by unauthorized persons.
Prior to installation, visually check if the product has any
A
defects on it. If so, do not have it installed. Damaged products
cause risks for your safety.
Make sure that the water inlet and discharge hoses as well
C
as the power cable are not folded, pinched or crushed while
pushing the product into its place after installation or cleaning
procedures.
Appropriate installation location
•
Place the machine on a rigid floor. Do not place it on a long
pile rug or similar surfaces.
•
Total weight of the washing machine and the dryer -with full
load- when they are placed on top of each other reaches to
approx. 180 kilograms. Place the product on a solid and flat
floor that has sufficient load carrying capacity!
•
Do not place the product on the power cable.
•
Do not install the product at places where temperature may
fall below 0ºC.
•
Place the product at least 1 cm away from the edges of other
furniture.
Removing packaging reinforcement
Tilt the machine backwards to remove the packaging
reinforcement. Remove the packaging reinforcement by pulling the
ribbon.
Removing the transportation locks
Do not remove the transportation locks before taking out the
A
packaging reinforcement.
Remove the transportation safety bolts before operating the
A
washing machine, otherwise, the product will be damaged.
1.
Loosen all the bolts with a spanner until they rotate freely (C).
2.
Remove transportation safety bolts by turning them gently.
3.
Attach the plastic covers supplied in the User Manual bag
into the holes on the rear panel. (P)
38
EN
Advertisement
Table of Contents
