Thread Color Sorting - Baby Lock Capella Instruction And Reference Manual

Table of Contents

 Selecting the length of jump stitch not to trim

When the thread trimming function

you can select the length of the jump stitch not to trim the

thread.

 Your customized setting remains after turning the

machine off and on.

Touch

to select the length of jump stitch.

For example: Touch

to select 25 mm (approx. 1 inch)

and the machine will not trim a jump stitch of 25 mm or

less before moving to the next stitching.

Memo

• If pattern has many trims, it is recommended to

select a higher jump stitch trim setting in order to

reduce the amount of excess tails on the wrong

side of fabric.

• The higher the jump stitch length selected, the

fewer number of times the machine will trim. In this

case, more jump stitches remain on the right side

of the fabric.

 When using Tajima embroidery data (.dst)

When using Tajima embroidery data (.dst), you can select

whether or not the thread is trimmed according to a

specified number of jump codes.

Memo

• The "DST" setting will be applied with the next

pattern that is loaded.

Check that the thread trimming function

turned on. (page 60)

Touch

, and then display page 1 of the settings

screen.

Touch

and

to select the number of jump

codes.

• For example, if [3] is specified, sequential 3 jump

codes will be converted to the trim code. But

sequential 2 jump codes will not be converted to the

trim code, it will be embroidered as the feed (jump)

stitch.

Note

• You need to set the jump number same as the

number that was used when the particular Tajima

data was created.

If the jump number is not matched, either

unexpected trim or no trimming at trim expected

point will happen.