Operating Modes - Hyundai H-ARI13-07H/I Instruction Manual

8.
6. TIMER
With the unit ON, press this button to set OFF timer or with
it OFF to set ON timer. Press this button once, a "ON(OFF)" will flash. Press "
set the number of hours in which the unit will be turned ON/OFF, with an interval of 0.5 hour
if less than 10 hours, or 1 hour if longer than 10 hours , and a range of 0.5-24 hours. Press it
again to confirm the setting, the "ON (OFF)" will stop flashing. If the timer button is not pressed
longer than 10 seconds after the "ON (OFF)" start flashing, the timer setting will be exited.
* If a timer setting is confirmed, pressing this button again will cancel it.
Note: When a ON timer is set, all function buttons (except SLEEP, DISPLAY and iFEEL
can't be set ) are valid and when the ON time set is up, the unit will operate as preset.
7. This button has two functions.
a. HEALTH
Press this button with the unit ON to activate health related functions, such as negative ion,
electrostatic precipitation, PM2.5 removal, etc, depending on the actual configuration of
each model. Press this button again to deactivate the HEALTH function.
b. iCLEAN
Press this button with the unit OFF, the remote controller will display "CL" and the unit will
automatically clean dust off the evaporator and dry it, to increase the cooling and heating
efficiency. The iCLEAN function runs for approximately 30 minutes, during which if the unit is
SET TEMPERATURE (°C)
AUTO
turned on with the remote controller or this button is pressed again, the iCLEAN will be deacti-
COOL
AUTO
DRY
COOL
vated.
HEAT
DRY
HEAT
8. Режим
Each time the "
SET
the " " is pressed, it will decrease by 1℃.
MODE
The temperature setting ranges from 16℃ (60℉)~32℃(90℉).
MODE TURBO
EN SLEEP
Note: The temperature cannot be set in AUTO or FAN mode, thus these two buttons are
SWING
SLEEP °C/°F
not functional.
9. TURBO SWING ANTI-F
SWING
Press this button only in COOL or HEAT mode to set TURBO on or off to speedy the cooling or
ANTI-F ELE.H HEALTH
heating. When TURBO is on, the air speed is HIGH. When TURBO is off, the air speed will restore
ECO
to previous status.
10. MODE
Press this button, you can select the running mode as follows:
AUTO COOL DRY HEAT FAN
Note: HEAT mode is not available for cool only units.
SET TEMPERATURE (°C)
AUTO
11. SLEEP
COOL
DRY
Press this button to enter SLEEP mode, which the unit will exit after 10 hours of continuous
HEAT
operation and restore to the previous status.
SET
Note:The SLEEP function cannot be activated in FAN mode.
12. SWING
MODE
Press this button to activate up/down swing and press it again to fix the swing position.
SLEEP
13. SWING
SWING
Press this button to activate left/right swing and press it again
ANTI-F
to fix the swing position.
14, 15. In this model, the functions are not provided

7. OPERATING MODES

Automatic operation mode
1. Press the "MODE" button, select the automatic operation mode.
2. By pressing the "SPEED" button, you can select the fan speed from LOW, MID, HIGH, AUTO.
3. Press the "ON/OFF" button, the air-conditioner starts to operate.
4. Press the "ON/OFF" button again, the air-conditioner stops.
Note: In the fan operation mode, the temperature settings is non-effective.
SET TEMPERATURE (°C)
AUTO FEAN
HIGH
COOL
SET TEMPERATURE (°C)
MID
DRY
HEAT LOW
FEAN
SET TEMPERATURE (°C)
HIGH
FEAN
MID
FEAN
AUTO HIGH
ON/OFF
LOW
HIGH
COOL
MID
DRY MID
LOW SET
или
LOW
HEAT ON/OFF
SET
ON/OFF " is pressed, the temperature setting will increase by 1℃ and each time
ON/OFF
MODE TURBO SPEED
SET
TURBO SPEED
SLEEP °C/°F DISPLAY
MODE TURBO SPEED
SPEED
°C/°F DISPLAY
SWING SWING iFEEL
SLEEP °C/°F DISPLAY
SWING iFEEL
DISPLAY
ANTI-F
ELE.H HEALTH TIMER
SWING SWING iFEEL
ELE.H HEALTH TIMER
iFEEL
ECO iCLEAN
ANTI-F
ELE.H HEALTH TIMER
ECO iCLEAN
TIMER
iCLEAN
ECO
iCLEAN
SET TEMPERATURE (°C)
FEAN
AUTO
HIGH
COOL
MID
DRY
HEAT LOW
FEAN
ON/OFF
HIGH
SET MID
LOW
ON/OFF
MODE TURBO SPEED
SLEEP °C/°F DISPLAY
SWING TURBO SWING SPEED iFEEL
°C/°F DISPLAY
ANTI-F ELE.H HEALTH TIMER
SWING iFEEL
iCLEAN
ECO
ELE.H HEALTH TIMER
iCLEAN
ECO
Electric air conditioner (split system)
SET TEMPERATURE (°C)
AUTO
COOL
DRY
HEAT
" or "
SET
MODE TURBO
SLEEP °C/°F
SWING
SWING
ANTI-F ELE.H HEALTH
iCLEAN
ECO
SET TEMPERATURE (°C)
FEAN
AUTO
HIGH
COOL
MID
DRY
LOW
HEAT
FEAN
HIGH
MID
ON/OFF
LOW
SET
"to
ON/OFF
MODE TURBO SPEED
SPEED
SLEEP °C/°F DISPLAY
DISPLAY
SWING SWING iFEEL
iFEEL
ANTI-F ELE.H HEALTH TIMER
TIMER
iCLEAN
ECO