Maintenance - Hyundai H-ARI13-07H/I Instruction Manual

Electric air conditioner (split system)
SET TEMPERATURE (°C)
Cooling/Heating operation mode
AUTO
COOL
DRY
Press the "MODE" button, select the Cooling or Heating operation mode.
HEAT
2. By pressing the "
SET
(60℉)~32℃(90℉), the display changes as you touch the button.
3. By pressing the "SPEED" button, you can select the fan speed from LOW, MID, HIGH, AUTO.
MODE TURBO
4. Press the "ON/OFF" button, the air-conditioner starts to operate.
SLEEP °C/°F
5. Press the "ON/OFF" button again, the air-conditioner stops.
SWING SWING
Note: The cold wind type has no heating function.
ANTI-F ELE.H
ECO
Fan operation mode
1. Press the "MODE" button, select the fan operation mode.
2. By pressing the "SPEED" button, you can select the fan speed from LOW, MID, HIGH.
3. Press the "ON/OFF" button, the air-conditioner starts to operate.
4. Press the "ON/OFF" button again, the air-conditioner stops.
Note: In the fan operation mode, the temperature settings is non-effective.
SET TEMPERATURE (°C)
Drying operation mode
AUTO
COOL
DRY
Press the "MODE" button, select the drying operation mode.
HEAT
2. By pressing the "
SET
(60℉)~32℃(90℉), the display changes as you touch the button.
3. By pressing the "SPEED" button, you can select the fan speed from LOW, MID, HIGH, AUTO.
MODE TURBO
4. Press the "ON/OFF" button, the air-conditioner starts to operate.
SLEEP °C/°F
5. Press the "ON/OFF" button again, the air-conditioner stops.
SWING
SWING
ANTI-F ELE.H
Backlight function (for remote controllers with such function only)
ECO
The remote controller has a backlight which can be turned on by pressing any button for the
convenience of operation in darkness. The backlight will be automatically turned off if there
is no operation within 10 seconds.

8. MAINTENANCE

• Before cleaning unplug the conditioner.
• Cleaning of the indoor unit and remote control board:
• Indoor unit and remote control board should be cleaned with a dry soft cloth.
• If the indoor unit is too unclean, moisten the cloth with cold water.
• It is prohibited to clean the remote control board with moist cloth.
• In order to avoid the damage of paint or details of the conditioner, do not clean it with brush-
es and do not leave them on the surface of indoor unit.
• In order to avoid the damage of surface or deformation of the conditioner details, do not
clean it with petrol, solvents, cleaning powders or other chemically active substances.
• Before a sustained interruption in the conditioner work:
• Turn the conditioner on for several hours in the FAN mode. It will allow you to dry its inner
• cavities
• Unplug the conditioner. Remove the batteries from the remote control board. Checks before
starting:
• Make sure that an air filter is installed.
• Make sure that air inlet and outlet grilles of the outdoor unit are not blocked by foreign
objects.
• Cleaning of air filter
• Air filter cleans the air entering the conditioner from dust and foreign particles. If the filter is
contaminated, the conditioner capacity decreases sharply.
• If the conditioner is operated permanently, the filter should be cleaned once per two weeks.
• If the conditioner is installed in a room with dusty atmosphere, then the air filter should be
cleaned more often.
• To remove the filter, open the indoor unit panel.
• Remove air filters. Clean the filter with a vacuum cleaner or rinse it in clean water. If the filter
is contaminated heavily, clean it with a soft brush and wash in diluted washing solution, then
dry it in a cool place.
• While cleaning the filter with the vacuum cleaner, hold it with contaminated surface up. While
washing the filter in water, hold it with contaminated surface down.
• Do not dry the filter in the sun or near a fire.
• Set the air filter to initial position and close the panel.
SET TEMPERATURE (°C)
AUTO FEAN
HIGH
COOL
MID
DRY
HEAT LOW
FEAN
HIGH
MID
ON/OFF
LOW
SET
"or " " button, you can set the temperature range from 16℃
ON/OFF
MODE TURBO SPEED
SPEED
SLEEP °C/°F DISPLAY
DISPLAY
SWING SWING iFEEL
iFEEL
ANTI-F
ELE.H HEALTH TIMER
HEALTH TIMER
ECO iCLEAN
iCLEAN
SET TEMPERATURE (°C)
FEAN
AUTO
HIGH
COOL
MID
DRY
LOW
HEAT
FEAN
HIGH
MID
ON/OFF
LOW
SET
"or " " button, you can set the temperature range from 16℃
ON/OFF
MODE TURBO SPEED
SPEED
SLEEP °C/°F DISPLAY
DISPLAY
SWING SWING iFEEL
iFEEL
ANTI-F ELE.H HEALTH TIMER
HEALTH TIMER
iCLEAN
ECO
iCLEAN
9.
EN