Nikon SB-104 Nikonos Manual page 27

8
Pressing the shutter release button
slightly
Check the flash shooting distance
range and be sure the ready-light and
the
(e)
in-focus indicator are lit up.
-If the electron ic analog display appears,
the operation is controlled by center·
weighted
TTL
flash . In this case, the main
subject is taken at the correct exposure,
I ..
~~~~~~h~~~:~
but if the electronic analog display is on .:. _
the plus side, the background exposure
I •
A
1m
~IG FS.~
will be too bright (over·exposed), or if it is
on the minus side, the background expo·
sure will be too dark (under·exposed). If
no special background effects are
needed, the photograph can be taken as
is with correct exposure.
For matrix balanced fill·flash operation ,
reset the aperture dial on the camera so
that the overexposure or underexposure
indicator goes out. Using the exposure
calculation chart (see page 41), be sure
the aperture value set is within the
shooting distance range.
9
Shooting
If both viewfinder ready-light and
S8-104 ready-light blink for about
three seconds after shooting , the
flash has operated at maximum
power.
-In this case, either reduce the object
distance, or select a smaller f·number.
27