Table of Contents
Advertisement
3
Open
the
battery chamber cap
by
lifting it up.
-The cover may be hard to open
if
the
O·ring isn 't properly lubricated.
In
this
case,
the O-ring should be relubricated.
(See page 12.)
4
Load the battery.
Insert the NiCd battery unit SN-104
into
the battery chamber securely,
aligning the battery positioning
notch with the battery lock release
lever (orange).
-Slide
the
battery
lock
release lever
(orange)
in
the direction of the arrow
(
~
) to remove the battery.
5
Raise
the
buckle.
-Hold down the battery chamber cap and
engage the buckle hook to raise the
buckle.
6
Lock the releasellock buckle.
-Slide the buckle lock and press the
release/lock buckle to the Speedlight.
-Check to be sure there is no gap between
the battery chamber cap and the
Speedlight. The buckle should be securely
locked.
+Note
Standby switch
The SB-104 is provided with a standby switch
to conserve battery power. Refer to page 37
for details on the standby switch.
16
Advertisement
Table of Contents
