Axxess AX-VL90032 Installation Instructions Manual page 4

•
For installations when a double DIN radio will be
installed, the factory radio will need to be disassembled,
and the radio display relocated in the dash
• Unclip (6) tabs securing the radio bezel to the
radio assembly, then remove the bezel. (Figure C)
• Remove (3) screws securing each radio pod to the
radio frame. Carefully unplug the wiring harness
from each pod, then remove the pods. (Figure D)
• Remove (4) screws securing the radio display to the
radio frame, then remove the display. (Figure D)
• Connect the AX-VL90032 harness to the
AX-VL90032 interface.
• Connect the ASWC-1 harness to the ASWC-1 interface,
and then to the AX-VL90032 interface.
Note: The factory antenna in these vehicles cannot
be reused. A Metra antenna, 44-UA200 (sold
separately), on the front glass is suggested.
4
INSTALLING THE AX-VL90032 INTERFACE
.
(Figure C)
(CONT)
(Figure D)