Troubleshooting, Corrective Actions - Krups EA810B70 Manual

Information on cycle number
Connect the appliance to the mains supply but do not switch it on.
buttons together, - Fig. 27.
Press the and
The LED flashes during the setting phase.
To go to "cycle number" mode, press and hold the
displaying the information - Fig. 29.
Cycle number:
- Less than 3000: 1 LED lit.
- Greater than 3000: 2 LEDs lit.
- Greater than 6000: 3 LEDs lit.
To exit settings mode, press
At each of these steps you can exit settings mode by pressing the
lights are off. These settings will be saved even if there is an electrical failure. You can modify these settings at any time
by repeating these steps.

TROUBLESHOOTING, CORRECTIVE ACTIONS

PROBLEM MALFUNCTION
Your appliance detects a fault.
The appliance does not turn on when the
pressed.
The coffee grinder makes a strange noise.
The steam nozzle makes a noise.
The steam nozzle on your appliance seems partially or
completely clogged.
The steam nozzle makes little or no milk froth.
No steam comes out of the nozzle.
The auto-cappuccino set makes little or no froth.
The auto-cappuccino set does not take in milk.
22
button for 3 seconds; all of the red LEDs flash three times before
.
button is
button if you have finished your settings. All of the
CORRECTIVE ACTION
Switch off and disconnect the appliance, remove the fil-
ter cartridge, wait for a minute and restart the appliance.
Check your fuses and plug sockets.
Check that the two power plugs are correctly pushed in
the socket.
There is a foreign body in the grinder. Disconnect the
appliance before investigating. See if you can extract
the foreign body using your vacuum cleaner.
Check that the steam nozzle is correctly attached to its
corresponding end piece.
Ensure that the opening in the end piece is not ob-
structed by milk residue or limescale. Unclog the holes
with the needle supplied with your appliance.
For milk-based drinks, use very fresh, very cold pas-
teurised or UHT milk. It is also advisable to use a cold
container. If the results do not improve, try changing the
brand of milk.
Empty the tank and temporarily remove the filter car-
tridge. Fill the water tank with mineral water which is
high in calcium (> 100 mg/l) and run successive steam
cycles.
Check that the accessory is correctly attached to the
appliance, remove it then replace it.
Check that the flexible tube is not obstructed or pierced
and that it is correctly attached to the accessory so as
to make it airtight. Rinse and clean the accessory (refer
to the "Auto-cappuccino accessory" chapter).