Table of Contents
Advertisement
C
D
Charging the battery
The battery charge status affects the camera performance. To maximize the performance
and the battery life, fully charge the battery using the specified charger and AC power
adapter, and then fully discharge it through normal use at least once.
• Damage caused by the use of an incorrect battery charger set is not covered under the
warranty.
• The battery may be warm after being charged or used. This is normal and not a
malfunction.
• When using the camera in a cold environment, keep the camera and its battery warm
by holding it inside your jacket or another warm protective environment.
Using multifunctional buttons
You can choose camera settings by pressing the 4-way control or the
1. Left/Focus:
• Scrolls left in menus.
• Selects a focus mode.
2. Up/EV:
• Scrolls up in menus.
• Sets EV (use
3. Right/Flash:
• Scrolls right in menus.
• Selects a flash mode.
4. Down/Drive:
• Scrolls down in menus.
• Selects a drive mode (Standard/Self-timer/Continuous Shoot/Interval Shoot/.
5.
: Confirms a chosen setting.
To remove the battery:
1. Open the battery/SD card cover.
2. Press and hold the battery.
3. Release the battery lock lever.
4. When the battery has come out a little, gently pull it
out the rest of the way.
5. Close the battery/SD card cover.
To charge the battery:
1. Insert the battery into the battery charger.
2. Connect one end of the AC power adapter to the
battery charger.
3. Connect the other end of the AC power adapter to a
wall outlet.
4. When the battery is being charged, the charger LED
indicator lights up in red. When the battery is fully
charged, it turns into green.
and
to select an exposure value).
Preparing the camera for use 3
button.
Advertisement
Table of Contents
