Table of Contents
Advertisement
Assembling the carburettor
Observe cleanliness when assembling the
carburettor. The slightest contamination can cause
malfunctions.
1.
If throttle and choke valves with shafts, lever
arms and springs have been removed, these
must be assembled. The springs are tightened
1-2 turns. Lubricate the shaft bearings using a
light oil.
2.
Fit the fuel screen by using the handle of a
small screwdriver.
3.
Assemble membrane (X) with gasket and
screw tight the pump cover (Z). See Figure 42.
4.
Fit the needle valve (J) with lever arm (G),
axle and spring. Screw in the screw (F).
See Figure 42.
5.
Check using a ruler or the like that the lever
arm is level with the cover. The lever arm can
be bent if necessary. See Figure 43.
6.
Fit the control diaphragm (D) with gasket (E)
and cover (C). See Figure 42.
7.
Do a pressure test.
34
– English
Fig 43
Repair instructions
Advertisement
Chapters
Table of Contents
