Checking The Charge Status Of The Rechargeable Battery; Set The Direction Of Rotation; Inserting/Replacing Bits; Handle Setting - Parkside 331133 1907 Original Instructions Manual

GB IE NI
Overload protection: The safety cut-off of
the device switches off in case of overload.
Release the On/Off switch, the device can
be switched on again after a few seconds.
Checking the charge status
of the rechargeable battery
The battery indicator (
state of charge of the battery.
• Press the On/Off switch, the state of
charge of the battery is displayed by
turning on the 3 coloured LED lights:
red-yellow-green => Battery fully
charged
red and yellow =>
Battery appr. half charged
red => Battery is empty, please charge.
Set the direction of
rotation
You can select the direction of rotation with
the direction switch (clockwise and anti-
clockwise direction) and secure the device
against accidental start up.
1. Wait for the device to shut-down.
2. Clockwise direction:
Press direction switch (8) to the
right.
3. Anticlockwise direction:
Press direction switch (8) to the
left.
4. Switch lock: Bring direction switch to
neutral position.
Direction switch may only be acti-
vated at a standstill to prevent dam-
age to the transmission.
12
CY
4) signalises the

Inserting/replacing bits

Prior to commencing any work
on the device, bring the direction
switch (
in order to prevent an accidental
start up.
1. Insert the desired bit (14) or bit holder
(15) into the bit adapter (1).
2. To remove the bit or bit holder pull the
bit or bit holder out of the bit adapter.

Handle setting

Prior to commencing any work on
the device, bring the direction switch
(
8) to the neutral position in order
to prevent an accidental start up.
The device can be locked in two hand
settings:
- Pistol grip position
- Rod position
Press the release key PRESS (2) and
turn the handle (6) of the device by
180°. It locks into place audibly.

Use as a torch

1. Press the on/off switch (5) on the un-
derside of the handle (6). The torch
lights up.
2. To switch off, press the on/off switch (5)
again.
Interchangeable
attachments
You can remove the cap (16) in order to
use compatible interchangeable attach-
ments for Series PAS 4 B2/B3 cordless
screwdrivers.
8) to the neutral position