Charging Process; Charging The Battery; Initial Operation; Switching On And Off - Parkside 331133 1907 Original Instructions Manual

i) Do not operate the
charger on a combusti-
ble surface (e.g. paper,
textiles). Risk of fire due to
heating during charging.
j) In order to minimise the
risk of electric shock,
pull the charger plug
out of the socket prior
to cleaning it.
k) If the power cable
for this equipment is
damaged, it must be
replaced by the manu-
facturer, a customer ser-
vice agent of the same
or a similarly qualified
person in order to pre-
vent hazards.

Charging process

Do not expose the battery to
extreme conditions such as
heat and impact. There is a
risk of injury from leaking
electrolyte solution! In case
of contact, rinse with water
or neutraliser and consult a
doctor if contact has occurred
with eyes etc.
Charge the battery only in
dry areas.
There is a risk of injury from
electric shock.
• The device may only be powered with
SELV (Safety Extra Low Voltage) as
marked on the device.
• Before initial use, charge the battery
installed in the equipment.
GB
• To charge the Li-ion battery integrated
in the appliance, use only the
JLH100501700B1 battery charger
supplied.
• In all cases, observe the applicable
safety information as well as the regu-
lations and directions for environmental
protection.
• Defects resulting from improper han-
dling are not subject to the guarantee.

Charging the battery

1. Connect the charging cable connector
(12) with the charging socket (13) of
the device.
Insert the USB plug (
charging cable into the charger (
2. Plug the charger (
trical outlet.
3. The battery indicator (4) lights up:
red => Start of charging
red and yellow =>
Battery appr. half charged
red-yellow-green =>
Battery fully charged.
4. After the charging process, disconnect
the charger (
supply.

Initial Operation

Wearing hearing protection reduces
the risk of hearing damage.

Switching ON and OFF

1. Press the on/off switch (7) to start
the device. The LED work light (9)
lights up during operation.
2. To turn it off, release the on/off
switch (7).
IE NI CY
11) of the
10) into an elec-
10) from the mains
10)
11