Auto Tuning - Nokia RM-362 Service Manual

RM-362; RM-363
RF Troubleshooting Instructions

Auto tuning

This phone can be tuned automatically.
Autotune is designed to align the phone's RF part easier and faster. It performs calibrations, tunings and
measurements of RX and TX. The results are displayed and logged in a result file, if initiated.
Hardware set up
Hardware requirements for auto tuning:
• PC (Windows 2000/NT) with GPIB card
• Power supply
• Product specific module jig
• Cables: 3 (alt.1) RF cable, 1 GPIB cable and DAU-9S
• Signal analyser (TX), signal generator (RX) and RF-splitter
Phoenix preparations
Copy the two phone specific ini-files, for example
specific folder, for example
Auto tuning procedure
1 Make sure the phone (in the jig) is connected to the equipment. Else, some menus will not be shown in
Phoenix.
2 The first time you are using automatic tuning on this phone model, on this computer, you will have to
Set loss for cables and jigs.
3 To go to autotune, select
4 If you need more assistance, please refer to the Phoenix
Issue 1
Figure 32 Supply point at BT & FM IC (N6000)
\Phoenix\products\RM-13\ .
Tuning (Alt-U) > Auto-Tune (Alt-A) from the menu.
COMPANY CONFIDENTIAL
Copyright © 2008 Nokia. All rights reserved.
or one device including all.
rm_13_tunings.ini and autotune_RM-13.ini, to a phone
Help .
Page 4 –9