Table of Contents
Advertisement
Short
Standard
Long
Extra long
Customising the "My coffee" quantity
The appliance is set by default to automatically
deliver 30 ml of "My coffee". To modify this
quantity, proceed as follows:
1. Place a cup under the coffee spouts (fig. 9).
2. Press the
icon repeatedly (fig. 8) until "My
coffee" is displayed.
3. Press the 1 cup icon
making the coffee;
4. Press the PRoG icon. The appliance starts programming;
5. As soon as the coffee in the cup reaches the required level,
press the STOP or
The quantity set has now been programmed.
Please note :
•
You can programme a single cup of coffee only.
•
To cancel programming of "My coffee", press the eXIt
PRoG icon.
Please note!
"My coffee" can be customised in all profiles (see
"Memorising your personal profile" on page 38).
Adjusting the coffee mill
The coffee mill is set by default to prepare coffee correctly and
should not require regulating initially.
However, if after making the first few coffees you find that
delivery is either too fast or too slow (a drop at a time), this
can be corrected by adjusting the grinding adjustment dial
(fig. 11).
Please note!
The grinding adjustment dial must only be turned when the
coffee mill is in operation.
For fuller bodied creamier coffee, turn
one click anticlockwise towards "1"
(finer ground coffee).
For faster delivery (not a drop at a time),
turn one click clockwise towards "7"
(coarser ground coffee).
These adjustments will only be evident after at least 2 cups of
coffee have been delivered.
If delivery is still too fast or too slow, repeat the correction,
turning the dial another click.
≃40
≃60
≃90
≃120
(fig. 10). The appliance starts
icon again.
tips for a hotter coffee
For hotter coffee, you should:
•
perform a rinse cycle before delivering the coffee, using
the "Rinsing" function in the menu;
•
if Energy Saving is disabled, place the cups on the cup
warmer until they are warm;
•
warm the cups by rinsing them with hot water (using the
hot water function);
•
set a higher coffee temperature in the menu.
Making espresso coffee using coffee beans
Important!
Do not use caramelised or candied coffee beans as they could
stick to the coffee mill and make it unusable.
1. Fill the container with coffee beans (fig. 12).
2. Place under the coffee spouts:
- 1 cup, if you want to make 1 coffee (fig. 9);
- 2 cups, if you want 2 coffees (fig. 13).
3. Lower the spout as near as possible to the cup. This makes
a creamier coffee (fig. 14).
4. Press the icon corresponding to the number of coffees
required (one cup
and 15).
5. The appliance starts making coffee. An image
corresponding to the type of preparation chosen is
displayed together with a progress bar which fills as
preparation proceeds.
Once the coffee has been made, the appliance prepares for use
again.
Please note:
•
While the appliance is making coffee, delivery can be
interrupted at any moment by pressing the stoP icon or
one of the coffee icons (
•
At the end of delivery, to increase the quantity of coffee
in the cup, just press one of the coffee icons (
) within 3 seconds.
Important!
If the coffee is delivered a drop at a time, too fast and not creamy
enough or too cold, read the tips in the "Troubleshooting"
section on page 45).
Various alarm messages could be displayed while using the
machine. Their meaning is explained in the section "Displayed
messages" (page 43).
Making espresso coffee using pre-ground coffee
Important!
•
Never add pre-ground coffee when the machine is off or it
34
or two cups
) (fig. 10
or
).
or
Advertisement
Table of Contents
Troubleshooting
