Advertisement
RULES FOR SAFE OPERATION
(Continued)
An extension
cord should not be used unless
absolutely necessary. Use of improper
extension cord could result in a risk of fire and
electric shock. If extensioncord must be used,
make sure:
a. That pins on plug of extension cord are the
same number, size and shape as those of
plug on charger.
b.
That extension cord is properly wired and in
good electrical condition;and
c.
That wire size is large enough for AC
ampere ratingof charger as specified
below:
Cord Length (Feet) 25 ft. 50 ft. 100 ft. 150 ft.
Cord Size (AWG)
16
16
16
14
Note: AWG = American Wire Gage
•
DO NOT OPERATE CHARGER WITH A
DAMAGED CORD OR PLUG. If damaged,have
replaced immediatelyby a qualifiedserviceman.
M
Do not operate charger if it has received a
sharp blow, been dropped, or otherwise
damaged in any way; take it to a qualified
serviceman.
Do not disassemble charger; take it to a
qualified serviceman when service or repair is
required. Incorrect reassembly may result in a
risk of electric shock or fire.
TO reduce riskof eleotnc shock, unplugcharger
from outlet before attempting any maintenance
or cleaning. Turning off controlswill not reduce
this risk.
M
Do not use charger outdoors.
M
Disconnect charger from power supply when
not in use.
M
SAVE THESE INSTRUCTIONS. Refer to them
frequently and use them to instructothers who
may use this tool. If you loan someone thistool,
loan them these instructionsalso.
IMPORTANT INFORMATION FOR RECHARGING BATTERIES
When usingyour screwdrivercontinuously,the batteries in your screwdriver will become hot. You should let your
screwdrivercool down for approximately30 minutes before attempting to recharge.
Note: This situationonly occurswhen continuous use of your screwddver causes the batteries to become hot. It
does not occur under normal circumstances. Refer to "CHARGING YOUR SCREWDRIVER" for normal
rechargingof batteries. If the charger does not charge your screwddver under normal circumstances,return both
the screwdriver and charger to your nearest Sears repair center for electr_,alcheck.
_L WARNING:
The operation of any power tool can result in foreign ot_yscts being thrown into your eyes,
which can result in severe eye damage. Before beginningpower tool operation, always wear
safety goggles or safety glasses with side shields and a full face shield when needed. We
recommend Wide Vision Safety Mask for use over eyeglasses or standard safety glasses
with side shields, available at Sears Retail Stores.
5
Advertisement
