LG FV141 H2BA Series Owner's Manual page 59

global_main.book.book Page 59 Thursday, April 13, 2023 9:41 AM
Symptoms
Too much/too little
detergent or softener
dispensed.
The ezDispense doesn't
dispense detergent/
softener.
There's foam on the
rinsing course, and
there's detergent left
on the clothes after the
washing.
After the washing,
there's a scum on the
cloth.
Detergent, softener
leaks from the lid of
the ezDispense
compartments.
Drying
Symptoms
Dry problem
Drying time is too long. The ambient temperature is low.
Possible Cause & Solution
The default dispense amounts setting may need to be changed.
• Check and change the default dispense amounts setting.
The ezDispense function is off.
• Turn on the ezDispense function.
The ventilation holes are blocked.
• Clean the ventilation holes for the lids on the compartments with warm
water.
The detergent or softener in the ezDispense compartments has
hardened.
• Clean the ezDispense compartments and change the detergent or
softener.
Detergent was used when rinsing.
• Please make sure that the detergent/softner is stored correctly. (right:
detergent / left: softener)
You need to clean the inside of the ezDispense system.
• When using both dispensers for liquid detergent, make sure to run the
ezDispense Nozzle Clean in advance.
You need the ezDispense compartment's horizontal maintenance.
• Leakage occurs when the ezDispense compartment is tilted. Slide the
ezDispense compartment out or in slowly and use both hands for safety.
The lid isn't fully closed.
• Securely close the lids to the ezDispense compartments. Be careful not to
lose the lids.
Possible Cause & Solution
Check water supply tap.
• Do not overload. Check that the washing machine is draining properly to
extract adequate water from the load. When load of laundry is too small to
tumble properly. Add a few towels.
• Turn off water supply tap.
• Make sure the temperature is allowable range.
TROUBLESHOOTING
59