LG FV141 H2BA Series Owner's Manual page 17

global_main.book.book Page 17 Thursday, April 13, 2023 9:41 AM
Connecting Screw-Type Hose to Tap Without
Thread
1
Loosen the 4 fixing screws
2
Remove the guide plate
to fit the adapter.
3
Push the adapter onto the end of the tap so
that the rubber seal is connected to be
watertight. Tighten the 4 fixing screws.
4
Push the inlet hose
c
that the rubber seal within the hose can adhere
completely to the tap and then tighten the
hose by screwing it to the right.
.
a
if the tap is too large
b
vertically upwards so
INSTALLATION
Connecting One Touch Type Hose to Tap
Without Thread
1
Unscrew the adapter ring plate
the 4 fixing screws.
2
Remove the guide plate
to fit the adapter.
3
Push the adapter onto the end of the tap so
that the rubber seal is connected to be
watertight. Tighten the 4 fixing screws and the
adapter ring plate.
4
Pull the connector latch plate
the inlet hose onto the adapter, and release the
17
and loose
d
if the tap is too large
e
down, push
f