Changing The Size Of The Lens; Preparation For Use; Adjusting The Lamp Support; Connecting The Power - GARANT 491495 160 User Manual

GARANT LED magnifying glass lamp
de
NOTICE
Uncovered magnifying glass
bg
Fire risk when exposed to sunlight.
» When not in use, cover the magnifying glass with the magnifying glass cover.
» Avoid exposure to direct sunlight.
da
Before using the magnifying glass, attach the magnifying glass cover to the lamp support.
6.4.

CHANGING THE SIZE OF THE LENS

en
E
i
Original spare parts can be ordered from the Hoffmann Group. Customer service.
fi
1. Switch off the lamp, disconnect it from the power supply.
2. Rotate the ring anti-clockwise until the recesses [1] are aligned with the unlocking symbols on the housing.
3. Remove the ring and take out the lens [2].
fr
NOTICE! Scratches on the lens. Put the lens down only on a clean surface.
7.

Preparation for use

it
7.1.

ADJUSTING THE LAMP SUPPORT

F
hr
NOTICE! Damage to the lamp. Do not rotate the joints contrary to their intended direction of rotation. When
loosening the joint screws, hold the lamp head tightly.
1. Undo the joint screw on the joint that is to be adjusted.
lt
2. Move the lamp support into the desired position.
3. Retighten the joint screws that were undone, until the lamp support is held in the desired position.
nl
7.2.

CONNECTING THE POWER

NOTICE
Wrong supply voltage
no
Damage to the lamp.
» Check the power supply against the rated voltage and frequency shown on the nameplate, and ensure they are
identical.
pl
7.2.1.

Connecting the lamp to the mains power supply

1. Connect the lamp to the power supply unit.
pt
2. Insert the mains plug into a mains socket.
7.2.2.

Connecting the lamp to the 24-V power supply (SELV)

ro NOTICE! Only a trained electrician may make the connection. Connect only to a Separated Extra Low Voltage
(SELV) power supply. Comply with the pin assignment in the plug.
sv
sk
sl
DC -
es
cs
hu
26
DC +
Not
assigned