Getting Started - Beurer AS 50 Instructions For Use Manual

G
ETTING STARTED
Insert battery/Change battery
If you do not want to insert or change the battery yourself,
please bring it to a watchmaker.
Change the battery in the morning before recording the activ-
ity. This is the only way to ensure that the daily recording is
not overwritten in the PC software EasyFit.
At first remove the activity sensor from the belt clip (see chapter "At-
taching the activity sensor", section "Wearing the activity sensor on
your belt/trouser waistband").
The battery compartment of the activity sensor is located on the back
of the monitor. Place the monitor with the front facing downwards on a
soft surface and insert the battery as follows:
1
Using a coin, turn the lid of the battery
compartment anticlockwise until the lid
comes off.
Remove the battery from the battery com-
partment with the aid of a pointed, non-
metallic tool, e.g. toothpick.
2
Put the battery into the battery com-
partmnt in such a way that the battery is
on top of the spring underneath the clip
(1) and the positive pole (+) faces up-
wards.
Check the seal. The seal has to lie flat in
the casing and there must be no visible
damage to it. The impermeability cannot
be guaranteed otherwise.
9
G
B