Cleaning And Care - Sharp KH-6V13NS0I-EU User Manual

display after the heater or the hob control
is turned off. The residual heat display is
shown as long as the calculated heater
temperature is > + 60 ° C.
The display of the residual heat has the
lowest priority and is overwritten by every
other display value, during safety turn offs
and displaying an error code.
After reapplying the supply voltage to
the hob control after an interruption of
the supply voltage has occurred, results
in the residual heat display flashing, if
the corresponding heater had a residual
heat of greater + 60 ° C before the power
interruption occurred. The display will
flash until the max. residual heat time
has expired or the heater is selected
and activated.

CLEANING AND CARE

Cookware with rough bottoms should
not be used since these can scratch the
glass ceramic surface. The bottoms of
good cookware should be as thick and
flat as possible. Before use, make sure
that cookware bottoms are clean and
dry.
Always place the cookware on the co-
oking zone before it is switched on. If
possible, always place the lids on the
cookware. The bottoms of the cookwa-
re must not be smaller or larger than the
cooking zones, they should be at the
proper size as indicated below, not to
waste energy.
CORRECT
FALSE
Before cleaning the hob, first remo-
ve the plug from the electrical supply
socket. Then ensure that there is no
residual heat stored in the appliance.
Vitroceramic glass is very resistant to
high temperatures and overheating. If
residual heat is stored in the appliance,
´H` will flash on the Heater Display. In
order to avoid burns, let the appliance
cool down.
Remove all split food and fat with a win-
EN - 18
FALSE
FALSE