Tascam US-428 Owner's Manual page 49

<<LOCATE Go to beginning of song
LOCATE>> Go to end of song
SET + <<LOCATE Set Memory Start to current
time
SET + LOCATE>> Set Memory End to current
time
Channel Controls:
The US-428 has 8 channel strips and a
master fader. The master fader controls
the volume for any and all tracks that
contain master faders. Regular channel
strip faders never affect a master fader
track.
Each channel strip contains a fader, a
S button, a S
ELECT
R , a M
ECORD LED UTE
M . The eight channel strips
UTE LED
affect a bank of eight contiguous tracks
within Digital Performer's Mixing Board
window. The set of tracks being
controlled may be changed as described
in the "Bank Selection" section below.
The channel fader directly controls the
volume of a track (unless it's a master
fader track). Select a track by pressing
the S button. The corresponding
ELECT
S will light. Pressing a S
ELECT LED
button will deselect any previously
selected track(s).
window active, the currently selected
track is highlighted.
Pressing S + S
ET ELECT
select state of a track.
used to select or deselect multiple
tracks, or to change the set of selected
tracks.
The P knob will control the panning
AN
for the selected track(s). Holding S
while panning gives you finer control.
The R button acts like a shift key with
EC
the S buttons. Holding R
ELECT
pressing a S button toggles the
ELECT
, a
ELECT LED
button, and a
ELECT
With the T
RACK
will toggle the
This may be
ET
and
EC
record enable state for that track. S
R clears all record-enabled tracks.
EC
The M buttons control both mute and
UTE
solo status of a track. When the S
is unlit, pressing a M
LED
toggles the mute status of a track, and
the M 's reflect the mute status of
UTE LED
the track. Pressing the S
toggles the Global Solo State, indicated
by the lit S . When the S
OLO LED
is lit, pressing a M
UTE
solo state of the track, and the M
reflects the solo status of the track.
(When the last track's S
the Global Solo Status is automatically
cleared by Digital Performer, and the
tracks' mute status is once again
shown.) S + S
ET OLO
when the S led is not lit, or clears all
OLO
solos when the S
OLO LED
Aux Send Controls:
Audio tracks have four aux send levels
and aux send mutes.
display the send field in the track
window.) To change these controls,
select a track(s) and press the A
A 2, A 3 or A 4 button. Its
UX UX UX
light, indicating that the D
now controls that function. Moving the
D W will now control the
ATA HEEL
selected Aux Send level for the selected
track(s). Holding S
ET
D W allows for finer control.
ATA HEEL
Pressing the currently selected A
button will turn off the A
D W will
ATA HEEL
operation. Pressing a different A
button will select a different Aux Send to
be controlled. Pressing S
button will toggle the corresponding
send mute status for the selected
track(s).
+
ET
OLO
button
UTE
button
OLO
led
OLO
button toggles the
UTE LED
is cleared,
OLO
clears all mutes
is lit.
(To see them,
1,
UX
will
LED
W
ATA HEEL
while moving the
UX
and the
UX LED
resume normal
UX
+ an A
ET UX
49