Macintosh; Setting Up Oms (Macos Only) - Tascam US-428 Owner's Manual

NOTE: You may be prompted by a
message informing
software you are about to install does
not have a digital certificate.
click "Continue the installation anyway"
and proceed.
If you are prompted to restart your
computer, do so.
Connect the
computer, plug it in, and turn it on.
The Windows plug-n-play will notice
a new USB device and start the Add
New Hardware wizard, which will
find the three needed files on its
own. This will take about 30-60
seconds.
The drivers are now installed and the
US-428 is ready to operate.
To install using
Hardware Wizard:
Unzip the driver files into a new
(empty) folder on the hard disk.
Connect the
computer, plug it in and turn it on
The Windows plug-n-play will notice
a new USB device and start the Add
New Hardware wizard.
Choose "Search for a suitable driver
for my device" and press Next
Enter the path where the drivers are
stored and press OK
After Windows finds the "firmware
download" driver, click Next
Click "Finish" · The other driver
components will be automatically
discovered and loaded
you that the
Simply
US-428 to the
Windows New
US-428 to the
Click "Finish" if prompted, and
reboot if prompted
Illustration 3.02 - Windows 98 New Hardware Wizard

3.2.2 Macintosh

Insert the CD-ROM
computer, double-click on the US-
428 installer,
instructions.
Connect the
computer, and connect power to the
unit. When the US-428 is connected
and powered up, the Mac will find
the drivers itself.
3.3 Setting Up OMS (MacOS
Only)
Cubasis, ProTools and several other
applications rely on OMS for MIDI
implementation. OMS (Open Music
System) is a standard
management on the Macintosh. Since
the US-428 relies on MIDI controller
commands for its communication with
into the
and follow its
US-428 to the
for MIDI
16