Overdubbing; Mixdown - Tascam US-428 Owner's Manual

program will enter Record mode. It will
stop recording when it reaches the drop
out point, or if none is enabled, when
you hit the STOP button.
Cubasis will now create a display of the
track(s) you've just recorded. This can
take a few seconds to a few minutes,
depending on how long the recorded
tracks are and how many there are.
You'll then see the tracks appear in your
arrange window.

7.3 Overdubbing

To overdub more tracks, simply select
and enable additional tracks as you did
the previous ones,
procedure. You can monitor the tracks
you've already recorded via the US-
428's outputs,
additional tracks into Cubasis via the
US-428's inputs. Be sure to assign
each track to its own channel in the
program's internal mixer. For
information on Cubasis'
functions, including groups and output
assigns, please refer to the Cubasis
manual.
When overdubbing, you can also select
the INPUT MONITOR mode by pressing
the INPUT MONITOR button on the
US-428. When the corresponding LED
is illuminated, channel strips 1,2,3 and 4
can be used to adjust the level, pan and
mute status of inputs A, B, C and D,
respectively. This will enable the first
four faders as Input level monitors,
allowing you to hear the inputs at the
source, in sync with the previously
recorded tracks.
and repeat the
while recording
more
mixer

7.4 Mixdown

You can control the mix of the channels
you've recorded via the US-428. Make
certain you've got
selected - the small on-screen window
that indicates "VST Mixer 1-8", or "GM
Mixer 1-8" or "GM Mixer 9-16" is your
best indication of the currently selected
bank. The LEDs next to the BANK
buttons on the US-428 also indicate the
selected bank:
VST Mixer
GM Mixer 1-8 =
GM Mixer 9-16 =
You can change the level of a track by
adjusting its corresponding fader on the
US-428 control surface. To adjust other
parameters on a particular channel, first
press the SELECT key for that channel
on the US-428. The selected channel
will be highlighted below that channel's
fader on the screen.
Moving the channel fader on the US-428
will adjust the relative volume of the
selected channel in
corresponding fader on screen will
update as you move the US-428's fader.
The PAN control on the US-428 will pan
the selected channel from Left to Right
on the stereo buss. To open the EQ
panel, select the desired channel and
then press ASGN and select any of the
four bands of EQ on the US-428's EQ
pod. The EQ's level, center frequency
and Q can then be controlled via the
US-428's EQ knobs.
To select a channel's FX sends, select
the desired channel and then press
ASGN and select any of the four AUX
buttons. The level of the Aux send is
controlled via the DATA WHEEL.
the correct bank
= only
and
only.
Cubasis. The
34