NIXON THE BASE TIDE - Watch Manual
![]()
TIME MODE
TIME MODE FEATURES
- hours, minutes and seconds display in 12 or 24 hour format
- month and date display or tide graph
To set the time on your watch:
- Press PUSHER B (MODE) until you are in Time Mode
- Press and hold PUSHER B to enter Time Mode setting state (seconds will begin to blink)
- Press PUSHER C to increment the value
- Press and hold PUSHER C to quickly increment the value
- Press PUSHER D to decrement the value
- Press and hold PUSHER D to quickly decrement the value
- Press PUSHER B to advance through second, hour, minute, year, month, date, 12/24hr
- Press and hold PUSHER B to confirm and exit setting state
- To switch between TIDE or DATE display on the Home Screen, press PUSHER C
- To peek the next tide event, press and hold PUSHER D
- To toggle hourly / button chime on or off, press PUSHER D
- Press PUSHER B to advance to TIDE MODE
TIDE MODE
TIDE MODE
features current, future, and past tide events, based on Basic Tide calculation
- Display will automatically show next tide event
- Press PUSHER C to advance to next tide event (after "TOMORROW" it will show the date)
- Press PUSHER D to scroll to previous tide event (before "TODAY" it will show the date)
To set the TIDE:
- Using a trusted tide data source, determine the time of the next high tide. This is the time you will set your watch to in the next steps.
- Press and hold PUSHER B to enter Tide Setting State (hours will begin to blink)
- Press PUSHER C to increment the value
- Press and hold PUSHER C to quickly increment the value
- Press PUSHER D to decrement the value
- Press and hold PUSHER D to quickly decrement the value
- Press PUSHER B to advance to minutes, and then seconds
- Press and hold PUSHER B to confirm and exit setting state
NOTE: Basic Tide is intended to give approximate tide event times. It should not be used for critical navigation purposes. For most accurate data, tide function should be reset periodically by following the steps above. - Press PUSHER B to advance to CHRONOGRAPH MODE
CHRONOGRAPH MODE
CHRONOGRAPH MODE features
- Hundredth seconds resolution
To operate the Chronograph:
- Press PUSHER C to start Chronograph run state
- In run state, press PUSHER C to stop the Chronograph
- Once stopped, press and hold PUSHER D to reset
- Press PUSHER B to advance to TIMER MODE
TIMER MODE
TIMER MODE features
- 7 preset timer options
- 1 customizable option
To set the TIMER:
- Press PUSHER D to cycle through the preset options, or select custom
If CUSTOM is selected (display will read: TIMER CU):
- Press and hold PUSHER B to enter Timer
Mode setting state
- Press PUSHER C to increment the value
- Press and hold PUSHER C to quickly increment the value
- Press PUSHER D to decrement the value
- Press and hold PUSHER D to quickly decrement the value
- Press PUSHER B to advance from minutes to seconds
- Press and hold PUSHER B to confirm and exit setting state
To operate the TIMER:
- Press PUSHER C to start the timer
- Press PUSHER C to stop the timer
- Press and hold PUSHER D to restart the timer
- Press any pusher to stop the alarm once time has expired
- Press PUSHER B to advance to TIME MODE
www.nixon.com
![]()
Documents / Resources
References
Download manual
Here you can download full pdf version of manual, it may contain additional safety instructions, warranty information, FCC rules, etc.
Download NIXON THE BASE TIDE - Watch Manual
Need help?
Do you have a question about the THE BASE TIDE and is the answer not in the manual?
Questions and answers