NIXON Re-Run - Two Button Digital Watch Manual

NIXON Re-Run - Two Button Digital Watch Manual

Advertisement

NIXON Re-Run - Two Button Digital Watch Manual

MODES

Overview
MODES: PRESS [B] Button to advance through modes.
TIME
TIME 2
ALARM
TIMER

SETTING THE TIME

SETTING THE TIME - Step 1 - Entering Time Settings
PRESS and HOLD [A] for 3 secs to enter Time Setting
12H/24H will blink

SETTING SEQUENCE IS: 12H/24H, Seconds, Hour, Minute, Year, Month, Day

SETTING THE TIME - Step 2
PRESS [A] button to advance through the setting sequence.

SETTING THE TIME - Step 3 - Changing current value
PRESS [B] button to change current value.

SETTING THE TIME - Step 4
PRESS and HOLD [A] for 3 secs to enter Time Setting
Hours will blink

SETTING SEQUENCE IS: Hour, Minute


PRESS [A] button to advance through the setting sequence.


PRESS [B] button to change current value.

ALARM MODE

ALARM MODE - Turning on and off
PRESS and HOLD [B] for 3 secs to turn the Alarm on and off.

ALARM MODE - Entering the alarm setting
PRESS and HOLD [A] to enter alarm setting, and then toggle between hour and min.

ALARM MODE - Increasing the current value
SETTING SEQUENCE IS: Hour, Minute PRESS [B] to increase current value.

TIMER MODE

TIMER MODE - Entering the Timer Setting
PRESS and HOLD [A] for 3 secs to enter Timer Setting
Hours will blink

SETTING SEQUENCE IS: Hour, Minute, Seconds

PRESS [A] button to advance through the setting sequence.

TIMER MODE - Changing the current value
PRESS [B] button to change current value.

TIMER MODE - Start/stop the countdown timer
PRESS [A] button to start and stop the countdown timer.

TIMER MODE - Resetting the countdown timer
PRESS [A] to reset the countdown timer. This is only possible when the timer is stopped.

When timer expires a single beep alarm will be heard.

BUCKLE ADJUSTMENT

  1. Flip Open Siize Adjustment Bracket where arrow is pointing using paper clip, small screw driver, or narrow / thin object.
    BUCKLE ADJUSTMENT - Step 1
  2. Move buckle up or down depending on size needs
    BUCKLE ADJUSTMENT - Step 2 - Move the buckle
  3. To lock adjustment bracket, line top bar up to center of 2nd and 4th links.
    This will allow buckle to sit at the seams of the links instead of on top of the links where closure will be too difficult.
    BUCKLE ADJUSTMENT - Step 3

LOCKING TO POSITION

  1. Take folded buckle piece and place hooks on to bar of adjustment bracket.
    LOCKING TO POSITION - Step 1 - take a buckle piece
  2. Hooks should sit comfortably on bar.
  3. Snap down top piece to secure.
    Top piece should make a click noise.
    LOCKING TO POSITION - Step 2 - Secure the buckle

WATER RESISTANCY RATINGS AND WATCH CARE

WATER RESISTANCY RATINGS

*RINSE WATCH WITH SOAP AND WATER AFTER 200m 200m 200m EXPOSURE TO SALT WATER OR SAND.

Replace the battery at least every two years. Dead or low batteries left in a watch may leak and destroy the movement of your watch. If you have a water resistant watch, know that the water resistancy is attained using rubber or plastic seals which will deteriorate under normal conditions and reduce the water resistancy of your watch. ese seals should be checked by an authorized jeweler at least every two years to ensure the rated water resistancy. Do not expose your watch to extreme temperatures (over 60ºC or 140ºF, under -10ºC or 14ºF). No hot tubs or saunas. Sorry, but do you really need to know the time when you're tubbing?
Avoid extreme shocks.

www.nixonnow.com

Documents / Resources

Download manual

Here you can download full pdf version of manual, it may contain additional safety instructions, warranty information, FCC rules, etc.

Download NIXON Re-Run - Two Button Digital Watch Manual

Advertisement

Need help?

Need help?

Do you have a question about the Re-Run and is the answer not in the manual?

Questions and answers

Table of Contents