Electrical wiring diagram for burners provided with printed circuit (standard configuration).
.As far as connections, refer to the terminal block shown on Fig. 18.
1
Connect the signal conductors from the boiler to the burner, as for the next elements (Fig. 19 - Fig. 21):
ST: thermostat/pressure switch series
TAB: High/low flame thermostat
2
Connect the signal conductors from the burner to the boiler, as for the next elements (Fig. 19 - Fig. 21)
LB: Burner's lockout signalling LED
LSPG: Gas proving system' lockout signalling LED
3
In case of modulating burners, the 5, 6 and 7 terminals, on the MA teminal block, are already connected to the regulating modula-
tor (mod. RWF40). A 4-pole plug coming out from the electrical panel is provided for the temperature and pressure probes connec-
tions (see Fig. 20).
Note: the regulating modulator is programmed according to the ordered probe
Fig. 19: Progressive burners
Fig. 21: Fully modulating burners
Fig. 18: Terminal board for connections on printed circuit
RWF40 >>>
Fig. 20: Probes connection
26