Table of Contents
Advertisement
AXIS P37-PLE Panoramic camera series
The web interface
Trigger delay: Enter the minimum time that the tampering conditions must be active before the alarm triggers. This can help
prevent false alarms for known conditions that affect the image.
Trigger on dark images: It is very difficult to generate alarms when the camera lens is sprayed, since it is impossible to distinguish
that event from other situations where the image turns dark in a similar way, for example, when the lighting conditions change.
Turn on this parameter to generate alarms for all cases where the image turns dark. When it's turned off, the device doesn't
generate any alarm when the image turns dark.
Note
For detection of tampering attempts in static and non-crowded scenes.
Shock detection
Shock detector: Turn on to generate an alarm if the device is hit by an object or if it is tampered with.
Sensitivity level: Move the slider to adjust the sensitivity level at which the device should generate an alarm. A low value
means that the device only generates an alarm if the hit is powerful. A high value means that the device generates an alarm
even with mild tampering.
Edge-to-edge
Pairing
Pairing allows you to use a compatible Axis network speaker or microphone as if it's part of the camera. Once paired, the network
speaker acts as an audio out device where you can play audio clips and transmit sound through the camera. The network microphone
will take up sounds from the surrounding area and make it available as an audio input device, usable in media streams and recordings.
Important
For this feature to work with a video management software (VMS), you must first pair the camera with the speaker or
microphone, then add the camera to your VMS.
Set a 'Wait between actions (hh:mm:ss)' limit in the event rule when you use a network paired audio device in an event
rule with 'Audio detection' as condition and 'Play audio clip' as action. This will help you avoid a looping detection if the
capturing microphone picks up audio from the speaker.
Address: Enter host name or IP address to the network speaker.
Username: Enter username.
Password: Enter password for the user.
Speaker pairing: Select to pair a network speaker.
Microphone pairing: Select to pair a microphone.
Clear fields: Click to clear all fields.
Connect: Click to establish connection to the speaker or microphone.
Logs
Reports and logs
45
Advertisement
Table of Contents
