Craftsman 486.24276 Operator's Manual page 8

Tractor snow cab

Hide thumbs Also See for 486.24276:

Enlarged version

STEP 10:

(SEE FIGURE 10)

Raise the tractor's hood.

insert the ends of the front brace rod into the inner set

of holes in the U-tube and rest the bottom of the brace

rod on the dash pane!. If the brace rod is too long to

rest on the dash panel, you can shorten the overall

length of the rod by inserting the upper ends of the

rod into one of the wider spaced sets of holes.

RAISE

HOOD

FRONT

BRAOE

ROD

FIGURE 10

STEP

11:

(SEE FIGURE 11)

With the tractor's hood still raised, place the snow cab

canopy onto the tubing frame and drape the front flap

down in front of the tractor% dash panel. Lower the

hood, trapping the front flap under the hood. Secure

the sides of the canopy by fastening the elastic hooks

to the bottom edge of the footrest and fender. Tie the

straps at back of canopy to the upright tubes. Any

levers or handles on snow throwers or snow blades

should be located outside of the cab.

LOWER

HOOD

FRONT FLAP

ELASTIC HOOK

FIGURE 11