Specific Installer Safety Instructions - Daikin RXTJ30A2V1B Installer's Reference Manual

3 Specific installer safety instructions

RXTJ-A_RXTA-C_RXTM-A_RXTP-A
R32 split series
4P728168-1 – 2023.03
Always observe the following safety instructions and regulations.
To handle the outdoor unit (see
CAUTION
To avoid injury, do NOT touch the air inlet or aluminium fins of the unit.
WARNING: MILDLY FLAMMABLE MATERIAL
The refrigerant inside this unit is mildly flammable.
Unit installation (see "6 Unit
WARNING
Installation shall be done by an installer, the choice of materials and installation shall
comply with the applicable legislation. In Europe, EN378 is the applicable standard.
Installation site (see "6.1 Preparing the installation
CAUTION
▪
Check if the installation location can support the unit's weight. Poor installation is
hazardous. It can also cause vibrations or unusual operating noise.
▪
Provide sufficient service space.
▪
Do NOT install the unit so that it is in contact with a ceiling or a wall, as this may
cause vibrations.
WARNING
The appliance shall be stored so as to prevent mechanical damage and in a well-
ventilated room without continuously operating ignition sources (e.g. open flames,
an operating gas appliance, or an operating electric heater). The room size shall be as
specified in the General safety precaution.
Opening the unit (see "6.2 Opening the
DANGER: RISK OF ELECTROCUTION
Do NOT leave the unit unattended when the service cover is removed.
DANGER: RISK OF BURNING/SCALDING
DANGER: RISK OF ELECTROCUTION
Piping installation (see
CAUTION
Piping and joints of a split system shall be made with permanent joints when inside
an occupied space except joints directly connecting the piping to the indoor units.
3 Specific installer safety instructions
|
"4.1.2 To handle the outdoor
4
installation" [ 24])
4
unit" [
4
"7 Piping installation" [
4
unit" [ 21])
4
site" [ 24])
28])
31])
Installer reference guide
15