Table of Contents
Advertisement
6 Plow Electronics Assembly
NOTE: Check 1/4" bolts provided in LED head-
light box. If they do not have a pre applied Loc-
tite patch, apply anti-sieze to the bolts to pre-
vent galling.
NOTE: Do not use an impact driver, tighten
bolts by hand to prevent galling and damage to
headlight housing.
1.
Mount the headlamp brackets to the lift
frame tube with hardware provided in light
parts box.
Remove the LH and RH headlamps from their
box and mount on the brackets with the pro-
vided hardware.
Refer to section titled "Headlamp Aiming
Procedure" for aiming instructions.
2.
Take the 38" power cable (38812008) from
the electronics parts box and the plow side
harness (38813155 for LED) or (38813098
for Halogen) from the headlight parts box.
PLOW ELECTRONICS ASSEMBLY
DWG. NO. 6012F
NOTE: To prevent corrosion lightly coat all elec-
trical connections, ring and spade terminals with
dielectric grease prior to assembly.
3.
Fasten the ring terminal of the solid black wire
of the power cable assembly to the stud that
the solenoid ground cables are running to on
the motor.
4.
Attach the ring terminal of the red striped wire
of the power cable assembly to the unoccu-
pied terminal on the motor.
5.
Connect the RH headlamp to the har-
ness end labeled "PSNGR SIDE" and the
LH headlamp to the end labeled "DRIVER
SIDE".
Advertisement
Table of Contents
