Table of Contents
Advertisement
1.
For Halogen lights Only: Before assembling
the power unit on the lift frame, scrape a
small amount of paint from the two mount
holes in the lift frame to provide a good
electrical ground for the turn signals and
parking lights.
2.
Mount the power unit on the lift frame with
two 3/8" x 3/4" hex bolts and two 3/8" lock
washers. The plastic reservoir of the power
unit should be to the left side of the plow,
see following illustration.
HYDRAULIC ASSEMBLY
DWG NO. 6595A
DWG. NO. 6484A
3.
Install the adapters into power unit, then
fasten the hoses to the adapters matching
the letter ends to the letters on the mani-
fold.
4.
Ensure factory installed fittings are tight.
Then secure hoses ensuring they clear the
lift links and latch handle.
NOTE: The fitting in the LH side angling cylin-
der may have to be adjusted slightly to route the
hydraulic hose to best avoid interference with
the latch handle and the lift links. Use plastic tie
straps to secure all hydraulic hoses away from lift
link stops.
Hydraulic Assembly 5
DWG NO. 6485A
Advertisement
Table of Contents
