Table of Contents
Advertisement
FRAME TO MOLDBOARD ASSEMBLY
1.
Place moldboard face down on cardboard
or other padding that will prevent scratches
in the paint.
Remove two side markers and four shipping
brackets from the ends of the moldboard.
Open the frame crate and set aside the
hardware bag, power unit box, electronics
box and springs for later assembly.
Snip the plastic tie straps holding the
hydraulic cylinders to the push frame and
rotate cylinders forward.
Carefully lift the frame assembly by
wrapping straps or padded chains around
both ends of the 2 1/2" square tube at the
rear of the frame assembly.
Fasten the frame assembly to the mold-
board assembly by lining up holes in the
push frame hitch plates with the reinforced
center hole through the pivot tube on the
back of the plow blade.
2.
DWG NO. 5698B
Frame to Moldboard Assembly 3
Install the 3/4" x 4 1/4" hex bolt so the bolt
head is retained by the lock plate on the
push frame. Secure the assembly with the
3/4" slotted nut and cotter pin so the plow
blade is free to pivot.
Use clevis pins and cotter pins to fasten the
hydraulic cylinder rods between lugs on the
moldboard.
Inside the hardware bag, find two threaded
spring studs and two 5/8" nylon insert lock
nuts.
Slide a spring stud onto each spring, then
assemble springs between lugs on the
moldboard pivot tube and channels along
the upper edge of the blade.
Tighten lock nuts until spring coils begin to
separate.
DWG NO. 5692A
Advertisement
Table of Contents
