Table of Contents
Advertisement
8 Truck Electronics & Mount Kit Assembly
TRUCK ELECTRONICS & MOUNT KIT ASSEMBLY
Truck Battery On Passenger Side
WARNING: Disconnect truck battery before
beginning electrical installation to avoid
shock hazard.
Open the electronics parts box and validate you
have all components, harnesses, and hardware
per the checklist inside the box.
NOTE: To prevent corrosion, apply a light coat
of dielectric grease on all connectors and termi-
nals before installation.
1.
Refer to drawing 8000 & 8001 for a general
guide on routing the HTBX electrical system
harnesses. Not all engine compartments
are compatible with the routing shown in
the drawings 8000 & 8001. Installers must
use their best judgement to route the har-
nesses ensuring everything is secured from
hot or moving components.
2.
If there is no access hole in the driver's
side firewall then drill a 1" diameter hole.
Route the 12 pin rectangular connector of
the controller harness (38828011) from the
HTBX controller through the firewall into the
cab compartment. If required, install the 4"
grommet in the hole.
CAUTION: Ensure that the electrical system
will clear any hood lift/spring mecha-
nisms before installation.
Advertisement
Table of Contents
