Table of Contents
Advertisement
12 System Checkout
NOTE: A new hydraulic lift cylinder may leak a
small amount of oil until packings become satu-
rated and produce a good seal. If leakage is ex-
cessive, or if leaking continues after initial cycling,
tighten the cylinder packing nut in 1/8-turn incre-
ments until leaking stops.
4.
Fasten the power unit cover assembly to the
lift frame bracket with two 1/4" x 3/4" screws,
flat washers and lock nuts from the hardware
bag in the power unit box. Tighten the lock
nuts so that the assembly is secure, yet the
cover hinges freely.
When the cover is closed, rods from the
latch handles should extend behind the
light brackets to hold the cover in place.
5.
NOTE: The power cable and wiring harness
must be connected between the snowplow and
truck to test the functions of the headlights and
power unit. Vehicle ignition must be switched
on.
6.
DWG. NO. 6310
7.
8.
9.
DWG. NO. 6014D
Assemble side markers on the ends of the
moldboard with 5/16" bolts, flat washers
and lock nuts.
Move the headlight switch on the joystick con-
troller to the "TRUCK" position and turn on
the vehicle headlights. High and low beams
should operate on the truck.
Turn the vehicles headlight switch to its off
position then move the switch to the "PLOW"
position. Plow lights should operate in both
high and low beams. Vehicle headlights
should be off.
Test the parking lights and turn signals. Lights
on the plow and truck should operate at the
same time.
In an area clear of bystanders, test joystick
functions by raising and lowering the plow
and angling side to side.
To reverse the angle functions, exchange the
tan and gray wires on the power unit.
Refer to the section titled "Controller Configu-
ration" for instructions on inverting the raise
and lower functions.
DWG. NO. 6006
Advertisement
Table of Contents
